1" Brass Union Pressure Tank Installation Kit - Fits Most Tanks Up to 16" Diameter | Water System, Well Pump & Plumbing Setup Accessories

I needed to replace a 20yo well pressure tank. The gauge and the shut-off valve were both rusted so I decided to just replace all of the brass associated with the tank while I was at it. I tried to figure out which individual parts I needed, but there were several different size connections involved. I'm not a plumber, so I was not confident in my ability match all the different parts. Then I found this kit. After determining the length of pipe that I needed from the tank to the tee, I ordered this kit. The kit even came with a FULL roll of teflon tape. I was able to put the entire kit together in about 20 minutes while sitting on the couch. Went to the garage and installed the 11" stem pipe in the pressure tank. Then I installed the assembled kit onto the existing house/well plumbing. Lastly, I connected the pressure tank with 11" stem pipe to the assembled kit. Opened the safety valve and turned on the well pump. Viola! We had water again.The pressure switch was preset (the new tank was already pressurized) so there were no adjustments to be made (Just be sure to get the kit that has the correct tank stem length and the correct pressure switch settings for your pressure tank). Total installation time was about an hour. I HIGHLY recommend this kit if you are replacing a well pressure tank with an 11" tank stem.. It would have taken me longer just to figure out what individual parts I needed, let alone order them, than it did to assemble and install this kit. The brass was heavy and the switch is name brand (Square D). The gauge and shut off valve also appear to be high quality. The kit also includes an over pressure valve, which my original setup did not have. Extremely happy with my purchase of this kit.